System bus (CAN / CAN−AUX) configuration
CAN management
8
174
EDBCSXA064 EN 3.2
8.8 CAN management
The system block CAN_Management
/CANaux_Management
ƒ serves to activate a reset node to e.g. accept changes in the transfer rate and
addressing.
ƒ serves to process statuses as Communication Error, Bus Off State, etc. in the PLC
program.
ƒ serves to influence the transmission time of CAN2_OUT/CANaux2_OUT and
CAN3_OUT/CANaux3_OUT.
ƒ serves to monitor the CAN communication.
Tip!
Detailed information on the SB CAN_Management can be found in chapter
13.6 ( 277).
Detailed information on the SB CANaux_Management can be found in chapter
13.11 ( 299).
To Next Page
Loading...
