Electrical installation
Terminal assignment
4
65
EDBPM−H505 DE/EN/FR 6.1
4 Electrical installation
4.1 Terminal assignment
Stop!
ƒ Damage of units connected. Connect the PE conductor as shown
in the figure!
ƒ Wire the operating unit only when no voltage is applied!
INPUT VOLTAGE: 18-32 VDC 10 W
FUSE 800 mA
+24 VDC
0 VDC
1
2
3
4
N. C.
MSP
N.C.
CAN+
Shield
CAN-
V-
12345
CAN-GND
CAN-LO
CAN-HI
~
PE
N
L1
+18…32VDC
1234
h505_001
Fig. 4−1 Assignment of the terminals
DC supply voltage
Terminal Identification Explanation
1 DC +24 V Supply voltage (DC +18 V ... 32 V)
2 DC 0 V GND supply voltage, reference potential
3 n.c. not connected
4 PE potential
System bus (CAN)
Terminal Identification Explanation
1V− GND Reference potential
2 CAN− LO System bus LOW (data line)
3 Shield Apply shield of the system bus cable
4 CAN+ HI System bus HIGH (data line)
5 n.c. not connected
To Next Page
Loading...
