Lenze Global Drive 8200 Series

Commissioning
5-2 820XBA1097
- In case of condensation connect the controller to mains
voltage only after the visible humidity has evaporated.
- The plug-in power terminals of the 820Xcontroller must only
be connected or disconnected when no voltage is applied.
Maintain the switch-on sequence!
5.2 Short set-up (Factory setting)
5.2.1 Switch-on sequence
Step
1.Switch on mains voltage
2.Select the direction of rotation. - CW rotation:
- Apply a LOW signal to terminal E4 (0...+3V).
- CCW rotation:
- Apply a HIGH signal to terminal E4 (+12...+30V).
3.Select the setpoint. Apply a voltage 0...+10 Vto terminal 8.
4.Enable the controller. Applya HIGHsignal (+12...+30V) to terminal 28.
5.The drive is now operating according to factory
setting.
All manuals and user guides at all-guides.com