Configuration
7-2 820XBA1097
7.2 Code table
How to read the code table:
Column Abbreviation Meaning
Code C013 Code C013
-
The parameter of the code can be different in PAR1 and
PAR2 .
-
The parameter value is accepted immediately (ONLINE).
C009*
-
The parameter value of the code is always the same in
PAR1andPAR2,butisalwaysdisplayedinPAR1.
C001
§
-
The parameter value of the code will be accepted after
pressing SH+PRG.
[C002]
-
The parameter value of the code will be accepted after
pressing SH+PRG but only if the controller is inhibited.
Name
820X
Name of the code.
Unit-specific setting possibilites (here for 820X).
Without unit designation the code is valid for all unit types.
Lenze Factory setting of the code
* The column ”Important” contains further information
Selection 1{1%}99Minimum value {smallest step/unit} maximum value
Info - Meaning of the code
IMPORTANT - Additional, important explanations of the code
To Next Page
Loading...
