Safety instructions
General safety and application notes for Lenze MOBILE devices
2
Ò
12
EDSMDAG EN 2.0
Electrical connection
When working on live devices, observe the applicable national regulations for the
prevention of accidents and technical measures for occupational safety and health.
The electrical installation must be carried out according to the appropriate regulations
(e.g. cable cross−sections, fuses, PE connection). Additional information can be obtained
from the documentation.
The documentation contains notes concerning wiring according to EMC regulations
(shielding, earthing, filters and cable routing). The compliance with limit values required
by the EMC legislation is the responsibility of the manufacturer of vehicles or systems or
machines.
Operation
If necessary, systems including these devices must be equipped with additional
monitoring and protection devices according to the valid safety regulations (e.g. law on
technical equipment, regulations for the prevention of accidents). The devices can be
adapted to your application by parameter settings. Please observe the corresponding
information given in the documentation.
After the devices have been disconnected from the supply voltage, all live components and
connectors must not be touched immediately because capacitors can still be charged.
Please observe the corresponding stickers on the devices.
Ensure that all protection covers are closed and screwed during operation.
Maintenance and servicing
The devices do not require any maintenance if the prescribed operating conditions are
observed.
The external cleaning of the devices has to be made in the course of the general care of the
vehicles, machines, or systems. Depending on the mounting place and the possible
pollution, the cover sensor has to be cleaned regularly.
Disposal
For a professional disposal and utilisation of the devices, please comply with the valid
regulations, e.g. 2000/53/EC (last amended by 2011/37/EC).
To Next Page
Loading...
