Lenze TML - Commissioning; Parameter Setting Overview; Electronic Programming Module (EPM)

10 Lenze 13466187 EDBTL03 v8 EN, DE, FR, IT, ES
Installation
Tml003
3.2.3 Connection diagram
WARNING!
• Hazard of electrical shock! Circuit potentials are up to 230 VAC above earth
ground. Capacitors retain charge after power is removed. Disconnect power and
wait until the voltage between B+ and B- is 0 VDC before servicing the drive.
• Do not connect mains power to the output terminals (U,V,W)! Severe damage
to the drive will result.
• Do not cycle mains power more than once every three minutes. Damage to the
drive will result.