Leser 526 API - References for Assembly Instructions; Disclaimer and Liability Information; Qualified Fitting Personnel Requirements; General Information for Assembly

LESER Global Standard
Assembly instructions for type 526 API
LGS 4104
Page 3/45
disclosure cat.:
II
proofread:
SSt
published date:
06/14/18
effect. date:
05/18
author:
Nieh
released by:
KUW
replaces:
initial
status:
Published
resp. depart.:
IE
date of release:
06/14/18
revision No.:
2
doc. type:
LGS
change rep. No.:
NA
retention period:
10
protected
3 References
LGS 3325 (LWN 322-04)
WI 3308-08 (LWN 308-08)
LGS 3323 (LWN 322-03)
WI 3324-01 (LWN 324.01)
4 Disclaimer
LESER puts in a great deal of effort into making up-to-date and correct
documentation available. Nevertheless, LESER GmbH & Co. KG gives no guarantee
that the recommended actions presented here are entirely correct and error free.
This document is to be used exclusively with the specified type. LESER GmbH & Co.
KG declines any liability or responsibility for the correctness and completeness of the
content.
LESER GmbH & Co. KG reserves the right to change the information contained in
this document, which is for the products of LESER GmbH & Co. KG and is intended
for LESER subsidiaries, at any time and without prior announcement.
LESER GmbH & Co. KG is available to the users of this document to provide
additional information.
5 Qualified fitting personnel
The assembly of LESER safety valves may only be performed by trained or qualified
fitters. The qualifications must be obtained through the appropriate training
measures.
6 General Information
 Gloves must be worn during the entire assembly.