Need help?Do you have a question about the LevelOne EAP-200 and is the answer not in the manual?
Details the EAP-200's connector panel and antenna panel with component descriptions.
Step-by-step instructions for placing and connecting the EAP-200 hardware.
Guide to accessing the console port for IP checks and factory resets using terminal software.
Instructions on how to access the device's web interface via a browser.
Details configuration for IP address, Netmask, Gateway, and DNS servers.
Instructions for setting wireless security types like None, WEP, 802.1X.
Guides on setting up MAC address filtering for access control.
Details the EAP-200's connector panel and antenna panel with component descriptions.
Step-by-step instructions for placing and connecting the EAP-200 hardware.
Guide to accessing the console port for IP checks and factory resets using terminal software.
Instructions on how to access the device's web interface via a browser.
Details configuration for IP address, Netmask, Gateway, and DNS servers.
Instructions for setting wireless security types like None, WEP, 802.1X.
Guides on setting up MAC address filtering for access control.
General| Wireless Standards | IEEE 802.11b/g/n |
|---|---|
| Frequency Band | 2.4 GHz |
| Maximum Data Rate | 300 Mbps |
| Ethernet Ports | 1 x 10/100 Mbps |
| Power Supply | 12V DC, 1A |
| Operating Temperature | 0°C to 40°C |
| Security | WEP, WPA, WPA2 |
| Operating Modes | Access Point, WDS |
| Humidity | 10% ~ 90% Non-Condensing |
To Next Page