Leviton EV Series - Warnings and Safety Instructions; Safety Instructions

1 WARNINGS
4
WARNINGS:
CAUTIONS:
Safety Instructions
• TO AVOID FIRE, SHOCK, DEATH, OR DAMAGE TO THE CHARGER, carefully read the charging
instructions in your vehicle’s manual before charging and heed the following warnings:
• TO AVOID INJURY OR DEATH:
• DO NOT put ngers into the electric vehicle connector.
• DO NOT remove cover or attempt to open the enclosure because of risk of electric shock.
• This device must be grounded.
• Do not use this device with an extension cord.
• DO NOT use this product if the exible power cord or EV cable is frayed, insulation-broken, or any other
signs of damage.
• DO NOT use this product if the enclosure or the EV connector is broken, cracked, open, or shows any
other indication of damage.
• This device should be supervised when used around children.
• The suitability of the use of exible cord in accordance with CE code, part I, rule 4-012, is to be determined
by the local inspection authority.
• To reduce the risk of re, connect only to a circuit provided branch circuit over-current protection in
accordance with the CSA C22.1–15 Canadian Electrical Code, Part 1 (Canada) or NOM-001-SEDE
Electrical installations (utility) (Mexico) or ANSI / NFPA 70 National Electrical Code (USA).
• Be sure to preview the user manual and ensure local building and electrical codes are reviewed before
installing the AC charger.
• The AC charger should be installed by a qualied technician according to the user manual and local
safety regulations.
• Use appropriate protection when connecting to the main power distribution cable
• Disconnect switch for each ungrounded conductor of AC input shall be provided by others in accordance with
the National Electric Code, ANSI/NFPA70.
• The device shall be mounted at height between 2 ft. (600 mm) and 4 ft. (1200 mm) from ground.
• Please keep the charger in a clean area with low humidity. Not recommended to be installed in coastal
environments with high humidity or high dust.
• Incorrect installation and testing of the charger could potentially damage either the vehicle’s battery and/or the
device itself. Any resulting damage is excluded from the warranty for the device
• Ensure that the charging cable is well positioned during charging so it will not be stepped on, tripped over, or
subjected to damage or stress.
• The device is designed only for vehicles that are compatible with the SAE J1772 Level 2 charging standard.
Model Output Amperage Circuit Breaker
EV40P 40A 50A
WEB VERSION