User Manual for LCO-i100 Console
www.levitronix.com
PL-4066-00, Rev03, DCO# 21-230
9 Appendix
9.1 Regulatory Status
9.1.1 CE Marking
We herewith declare that the PuraLev
®
Console LCO-i100, in its configurations as listed below is in conformity with the
below described European Directives. The console is thought to be used in laboratory and industrial production
environment of Life Science markets like Biotech and Pharmaceuticals.
LCO-i100.x-yy with x = various hardware configuration options and yy = various firmware options.
Consoles with 24 VDC for up to 160W supply input.
Note: The standard specified AC/DC power supplies for 50 and 160W are commercially available NRTL certified components.
Compatible CE certified IPD-30.x drivers (24 VDC) of the PuraLev
®
i30SU pump system.
Compatible CE certified IPD-100.x drivers (24 VDC) of the PuraLev
®
i100SU pump system.
Compatible CE certified IPD-600.x drivers (48 VDC) of the PuraLev
®
i600SU pump system.
Single-Use DCP-30.x pump heads of the PuraLev
®
i30SU pump system.
Multi-Use LPP-300.x pump heads of the PuraLev
®
i130MU pump system.
Single-Use DCP-200.x pump heads of the PuraLev
®
i100SU pump system.
Multi-Use LPP-200.x pump heads of the PuraLev
®
i100SU pump system.
Single-Use DCP-600.x pump heads of the PuraLev
®
i600SU pump system.
Clamp-on flow sensors of the LEVIFLOW
®
LFSC-D and LFSC-iX Series.
Single-Use sensors of the LEVIFLOW
®
LFS-SU Series.
Various signal adaptor cables for LEVIFLOW
®
flow sensors.
Machinery Directive 2006/42/EC:
The machinery directive essentially has been followed by a risk analysis, according mitigation actions and a user manual
for safe operation. For the design and testing the following standards are used as a guideline:
Safety for machinery – principles for risk assessments: used for system risk analysis.
Degree of protection provided by enclosure (IP code).
Low Voltage Directive 2014/35/EC:
The low voltage directive essentially has been followed by a risk analysis, electrical safety testing and a user manual for
safe operation. For the design and testing the following standards are used as a guideline:
Safety requirements for electrical equipment: tested at certified 3
rd
party laboratory.
Fulfilled by the specified standard commercially available AC/DC powers supplies.
Safety for machinery – principles for risk assessments: used for system risk analysis.
EMC Directive 2014/30/EC:
The following standards of the EMC directive are tested and confirmed:
Electrical equipment for measurement, control and laboratory use – EMC requirements
9.1.2 IECEE CB Safety Certification
The Levitronix
®
LCO-i100 Console is 3
rd
party tested and certified by Electrosuisse following the IECEE CB
Scheme according to the following safety standards:
Safety requirements for electrical equipment for measurement, control and laboratory use.
9.1.3 NRTL/ETL Safety Certification and Marking
The Levitronix
®
LCO-i100 Console is tested by the US national recognized laboratory (NRTL) Intertek according to the
following safety standards:
Safety requirements for electrical equipment for measurement, control and laboratory (US Standard).
CSA-C22.2, No. 61010-1-12
Safety requirements for electrical equipment for measurement, control and laboratory use (Canadian Standard).
9.1.4 Disposal of Equipment – WEEE Directive 2012/19/EU
Follow local legislation for disposal of equipment. In the European Union (EU) marked ( ) devices are governed by the
European WEEE Directive 2012/19/EU. Do not dispose with normal waste.
To Next Page
Loading...
Need help?
General
