EN
6
Air Quality Indicator Chart
Indicator
Color
Air
Quality
Auto Mode
Fan Speed
Blue Very Good Sleep Mode
Green Good Low
Orange Moderate Medium
Red Bad High
USING YOUR SMART AIR PURIFIER CONT.
Light Detection
Timer
You can turn on/o Light Detection in the VeSync
app. When this mode is turned on, the light sensor
will automatically adjust air purifier settings based
on the amount of light in the room.
You can manually set the timer for 2, 4, or 8 hours
using the button. You can also set the timer for
1–24 hours through the VeSync app.
• The display will automatically turn o when
the room gets dark. If the air purifier is in Auto
Mode or Pet Mode, it will not use the high
or turbo fan speeds, even if the air quality is
poor, to avoid making too much noise.
• When the room becomes light again, the air
purifier will return to its previous settings. The
display will automatically turn back on, and
Auto Mode will no longer be limited.
1.
Tap repeatedly to select a time. The timer
will start automatically.
Note:
• The indicators are not buttons and cannot be
used to select a time.
• The timer indicators will light up blue when active.
• When the timer is set through the VeSync app,
the indicator will light up instead. Once the
timer has finished, the air purifier will turn o.
Note:
• You can change the fan speed at any time
while the timer is on.
• The timer will restart if the time is changed.
2. To cancel the timer, tap until all timer
indicators are o. You can also turn the timer
o in the VeSync app.
Pet Mode
Pet Mode is ecient at filtering allergens from
the air while conserving energy.
1. Tap to turn Pet Mode on.
2. will light up while Pet Mode is on.
3. The air purifier will run for 15 minutes at high
speed (3 indicator lights), then 60 minutes
at medium speed (2 indicators), and cycle
between the two fan speeds.
4. Pet Mode will stay on unless you select a
dierent mode or fan speed.
5. To switch from Pet Mode, tap Auto Mode,
Sleep Mode, or select a fan speed on the air
purifier’s display or in the VeSync app.
Note:
• If the light sensor detects the room is dark,
the display will turn o and limit Pet Mode
to medium fan speed (2 indicators), to avoid
making too much noise.
• When the light sensor detects that the room
is lit again, Pet Mode will no longer be limited,
and the air purifier will run at medium fan
speed (2 indicators) for 30 minutes, then run
at high (3 indicators) for 15 minutes.
• After this, the normal Pet Mode cycle will start
(15 minutes at high speed, then 60 minutes at
medium speed).
Display Lock
When the air purifier is on, you can lock the
display to prevent settings from being accidentally
changed. Buttons will not respond to being tapped.
1.
Press and hold for 3 seconds to lock the
display. The Display Lock Indicator will light up
above the button.
Note: If the display is turned o, the Display Lock
Indicator will flash 3 times to show that the display
has been locked, then turn o.
2. The Display Lock Indicator will blink when any
other button is tapped to indicate that Display
Lock is on.
3. Press and hold again for 3 seconds to unlock
the display. The Display Lock Indicator will turn o.
Standby Mode
The air purifier is in Standby Mode when it is
turned o, but plugged in.
Note:
• In Standby Mode, the infrared dust sensor
will still detect the surrounding air quality and
give you updates in the VeSync app.
• Display Lock (available in the VeSync
app) can be used while the air purifier is in
Standby Mode to keep the air purifier from
being turned back on.
To Next Page
Loading...
Need help?
General
