8
GETTING STARTED
1st
2nd
3rd
Carbon
Filter
HEPA
Filter
1. Open the back cover of the air purifier and remove both
filters from their plastic packaging. [Figure 1.1]
Figure 1.1
Figure 1.3
Figure 1.4
Figure 1.5
Figure 1.6
foam piece
Figure 1.2
Note: Do not remove the foam piece attached to the dust sensor
cover unless instructed by Customer Support. [Figure 1.6]
2. First, place the Activated Carbon Filter back into the
air purifier. Then, place the Preliminary/True HEPA
Combination Filter. Make sure the pull tabs on both
filters are facing out. [Figure 1.2]
3. Replace the back cover by lining up the cover’s feet
with the matching slots on the bottom of the housing.
Make sure that the triangular piece at the bottom of the
cover is touching the safety switch. [Figure 1.3]
4. Push the cover closed. [Figure 1.4]
5. Place the air purifier on a hard, flat surface. [Figure 1.5]
Leave 38 cm (15 in) of clearance on all sides of the purifier.
To Next Page
Loading...
