Lexicon LXP-5 - REV 1 User Manual

4-12
LXP-5 Owner's Manual
Reverb Parameters
Parameter # Range: Increment Resolution
Pitch/Delay Delay/Reverb
Decay Time 11 0.5-12 seconds 0.5 sec.-infinity varies 15 steps P/D
min. is 0.1 sec. 16 steps D/R
Function: Adjusts mid reverb time. Infinite reverb is available in Delay/ Reverb algorithm only.
Treble Decay 12 320 Hz 320 Hz logarithmic 16 steps
to full range to full range
Function: Provides an adjustment of the low pass filter within the reverb. Maximum setting
gives a flat response through the filter section.
Bass Multiply 13 x0.3 to x2.5 x0.3 to x2.5 linear 32 steps
Function: Provides control over bass reverb time.
Size 14 8 - 26 meters 8 - 53.5 meters linear 26 steps P/D
64 steps D/R
Function: Adjusts the room size. The range is for one side of a room; cube these values to
get the approximate room volume.
Diffusion 15 0 - 100% 0 - 100% 1% 101 steps
Function: Softens the attack of percussive sounds in the reverberator.
Equalization Parameters
Parameter # Range: Increment Resolution
Pitch/Delay Delay/Reverb
High Cut Filter 16 320 Hz 320 Hz logarithmic 16 steps
to full range to full range
Function: Provides adjustment of high frequency roll-off. Maximum setting gives flat response
through the filter section.
Low Cut Filter 17 Full range Full range logarithmic 32 steps
to 1350 Hz to 1350 Hz
Function: Provides adjustment of low frequency roll-off. Minimum setting gives flat response
through the filter section.

Lexicon LXP-5 - REV 1 Specifications

General

Brand	Lexicon
Model	LXP-5 - REV 1
Category	Recording Equipment
Language	English