Lexicon
2-12
PCM 91 User Guide
Row 3
MIDI
3.0 Reset
This control resets all patched parameters to their previously stored values.
When this control is activated, a MIDI "Reset All Controllers" message is also
transmitted on the current channel by the PCM 91.
3.1 Receive
Turn ADJUST to select OFF, 1-16, or OMNI for receipt of MIDI messages.
3.2 Transmit
Turn ADJUST to select OFF, or 1-16 for transmission of MIDI messages.
3.3 Pgm Change
This control specifies the PCM 91's response to incoming MIDI Program Change
messages. There are four selections available via ADJUST: On, Off, Map and
Chain.
Pgm+ and Pgm –, are available as subparameters in each location. Pgm+ will
load the next higher effect in the current bank, map , or chain. Pgm – will load
the next lower effect. You can select the following sources to activate Pgm+ and
Pgm –:
Off
Footswitch 1
Footswitch 2
•
•
•
MIDI Controller #119
On
Program Change messages 0-49 correspond to PCM 91 Effects 0.0-4.9 in the
current bank. Program Change messages 50—127 are ignored. The current
bank can be changed with MIDI Continuous Controller 32 and Bank Select
Messages as follows:
0–8: Program Banks 0–8
9-10: Internal Register Banks 0-1
11-15: reserved for ROM Card Banks
16-24: Memory Card Banks. The number of banks available on a given
card will vary with its size, as follows:
Card Size # Banks
64 1
256 5
512 10
1 Meg 20
Off
All Program Change and Bank select messages are ignored.
To Next Page
Loading...
