2-13
Basic Operation
Map
Program Change 0-127 can be mapped to any PCM 91 effect in any internal or
card bank. Two 128 element maps are stored internally, additional maps may
be stored on RAM cards. Once you have selected Map, press Load/✱ to display:
Turn ADJUST to select the desired Program Chain. When set to MIDI, Program
Chains will be loaded by MIDI Program Change messages according to the
settings of Chain Pgm Assign in Row 6.
To load a specific Program Chain, without sending the PCM 91 a MIDI Program
Change message, use ADJUST to display the desired chain number.
MIDI Pgm Change
3.3 ✱MapSelect 0
Turn ADJUST to select the desired Program Change Map.
Chain
Any Program Change number can be selected to load any one of ten
customized effect “chains". Additional chains can be stored on RAM cards. Once
a chain is loaded, effects in the chain are accessed by the controller patched to
Pgm + and Pgm – (program increment and program decrement). Once you
have selected Chain, press Load/✱ to display:
MIDI Pgm Change
3.3 ✱Chain MIDI
MIDI Pgm Change
3.3 ✱Chain 3
3.4 Automation
This control is provided to allow one PCM 91 to act as a master for any number
of slaved PCM 91s. Select On to have values resulting from front panel
operations sent out as SysEx messages. Press Load/✱ to select the ID (0-126
or All) of the target PCM 91(s).
Automation sends all MIDI commands in PCM 90 format which can be received
by either a PCM 90 or a PCM 91. This means that Automation mode can control
both PCM 90s and PCM 91s, and that a PCM 90 can control a PCM 91 in
Automation mode. As the PCM 90 does not have banks 5-8, it will not recognize
programs from those banks in Automation mode.
3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST, Custom 1-4)
If Transmit is set to On these controls can transmit MIDI controller messages.
Press Load/✱ to cycle through the controller selections. Use ADJUST to select
the MIDI Controller message to transmit. Receipt of MIDI Controller messages
will affect the PCM 91 in the same manner as if the internal controls were
adjusted.
To Next Page
Loading...
