2-37
Basic Operation
Changing the default destination values
Let’s modify the patch further by adjusting the Destination values to a more
useful range.
Press Load/✱ repeatedly until the Patch 2 Values screen is displayed.
Notice that the ✱ is to the left of the Source value. This indicates that the Source
value is selected and its value will be changed when you turn ADJUST.
Press Load/✱ once to move the ✱ to the right of the Source value. When the
✱ is in this position, ADJUST will change the Destination value.
Patch 2 Values
000 : ✱ –360 MONO
Patch 2 Values
✱ 000 –360 MONO
Press Load /✱ to move the asterisk to this position,
where it indicates that Destination values will be
altered when you turn ADJUST.
The asterisk (✱) indicates that the Source value
will be altered when you turn ADJUST.
Patch 2 Values
000 : ✱ +0 MONO
Next, we’ll want to adjust the Destination value when LFO1 is at its maximum
value. One way to do this is to press Load/✱ three times to cycle the ✱ to the
display of the Source value, and continue on from there — but we’ve provided
a short cut! Press Edit to jump to the next assigned value ( in our example, the
maximum value for LFO1).
Patch 2 Values
127 : ✱ +360 MONO
Now our example has been modified so that LFO1 sweeps the Out Width Value
from 0 to 90. This creates a dynamic alteration of the effect’s spatial character-
istics. Its stereo image changes smoothly from mono to stereo, to surround, and
back again.
Note that the ✱ remains in the same position, so you can just turn ADJUST to
set the new Destination value. Set the value to +90.
Patch 2 Values
127 : ✱ +90 L-R, R-L
With the Destination value selected, turn ADJUST clockwise to set the value to
+0.
Patch 2 Values
✱ 000 –360 MONO
To Next Page
Loading...
Need help?
General
