Auto LF
Requires a line feed to occur.
• On—A line feed is performed for each Carrier Return (CR) code received.
• Off—A line feed does not occur when a CR code is received.
Note: Off is the factory default setting.
Auto CR
Requires a CR to occur.
• On—A CR is performed for each line feed code received.
• Off—A CR does not occur when a line feed code is received.
Note: Off is the factory default setting.
Zero Slash
• On—The zero (0) prints with a slash down the middle.
• Off—The zero (0) prints without a slash down the middle.
Note: Off is the factory default setting.
Download to NLQ II (available for 2580+ or 2581+ models only)
• Enabled—This reserves a portion of the receive buffer for downloading fonts.
• Disabled—This uses the entire buffer as a receive buffer.
Note: Enabled is the factory default setting.
Download (available for 2590+ or 2591+ models only)
• Enabled—This reserves a portion of the receive buffer for downloading fonts.
• Disabled—This uses the entire buffer as a receive buffer.
Note: Enabled is the factory default setting.
Code Page Sub.
• Enabled—This substitutes code page 858 for 850 to allow older programs access to the European characters.
• Disabled—There is no code page substitution.
Note: Disabled is the factory default setting.
Control options
Note: Use Setup mode to configure the printer according to your needs. To print a list of all default settings, press
LineFeed from the Main menu.
The following list items outline and explain the Control options and settings you can use with the printer:
Understanding Setup mode and menu options 52
To Next Page
Loading...
