Administrative support
Restoring the factory default settings
Restoring the US factory default settings
The factory default settings for the United States are:
• Code pages: 437
• Character Set: 1
• Form length: 11 inches
To restore the factory default settings:
1 Make sure the ribbon cartridge is installed and paper is loaded.
2 Press and hold Start/Stop for five seconds.
3 Open the ribbon access cover.
4 Move over the printhead toward the control panel side of the printer until it stops.
5 Close the ribbon access cover.
6 Press and hold Tear Off and Load/Unload , and then press Start/Stop.
7 Continue holding the buttons until the carrier moves.
Notes:
• The control panel lights blink on and off several times.
• The factory default settings have been restored when the carrier moves.
Restoring the European Union factory default settings
The factory default settings for the European Union are:
• Code pages: 858
• Character Set: 2
• Form length: 12 inches
To restore the factory default settings:
1 Make sure the ribbon cartridge is installed and paper is loaded.
2 Press and hold Start/Stop for five seconds.
3 Open the ribbon access cover.
4 Move over the printhead toward the control panel side of the printer until it stops.
5 Close the ribbon access cover.
6 Press and hold Tear Off and Tractor, and then press Start/Stop.
7 Continue holding the buttons until the carrier moves.
Administrative support 58
To Next Page
Loading...
