Setting Value
Device Password Authorization code
Note: To create an authorization code, from the e‑mail home page, click
Settings > More settings > User‑end POP/IMAP/SMTP, and then enable
Authorization code status.
Notes:
• If you encounter errors using the settings provided, then contact your e‑mail service provider.
• For e‑mail service providers that are not on the list, contact your provider and ask for the settings.
Loading paper and specialty media
Setting the paper size and type
1 From the home screen, navigate to:
Settings > Paper > Tray Configuration > Paper Size/Type > select a paper source
2 Set the paper size and type.
Configuring
Universal paper settings
1 From the home screen, touch Settings > Paper > Media Configuration > Universal Setup.
2 Configure the settings.
Loading trays
CAUTION—TIPPING HAZARD: To reduce the risk of equipment instability, load each tray separately.
Keep all other trays closed until needed.
1 Remove the tray.
Note: To avoid paper jams, do not remove trays while the printer is busy.
Set up, install, and configure 39
To Next Page
Loading...
