Lexmark E260dn Series User Manual

THE TONER MAY SMEAR WHEN PAPER IS FED FROM A SPECIFIC SOURCE
From Print Properties, the print dialog, or the printer control panel, select another tray or feeder to feed the paper
for the job.
THE TONER CARTRIDGE MAY BE DEFECTIVE
Replace the toner cartridge.
MAKE SURE THE PAPER PATH IS CLEAR
Paper could be caught between the photoconductor kit and the fuser. Check the paper path around the fuser area.
CAUTION—HOT SURFACE: The area of the printer near the fuser is hot. Allow the area to cool before removing
paper from this area.
Clear any paper you see.
THERE MAY BE EXCESS TONER IN THE PAPER PATH
Contact Customer Support.
Streaked vertical lines
These are possible solutions. Try one or more of the following:
THE TONER MAY SMEAR WHEN PAPER IS FED FROM A SPECIFIC SOURCE
From Print Properties, the print dialog, or the printer control panel, select another tray or feeder to feed paper for
the job.
THE TONER CARTRIDGE IS DEFECTIVE
Replace the toner cartridge.
MAKE SURE THE PAPER PATH IS CLEAR
Paper could be caught between the photoconductor kit and the fuser. Check the paper path around the fuser area.
Warning—Potential Damage: Do not touch the photoconductor on the underside of the photoconductor kit.
Use the cartridge handle whenever you are holding the cartridge.
CAUTION—HOT SURFACE: The fuser and the inside of the printer near the fuser may be hot. To reduce the
risk of injury from a hot component, allow the surface to cool before removing paper from this area.
Troubleshooting
138

Lexmark E260dn Series Specifications

General

Brand	Lexmark
Model	E260dn Series
Category	Printer
Language	English