Lexmark E360D series User Manual

Drawers
These are possible solutions. Try one or more of the following:
MAKE SURE THE PAPER IS LOADED CORRECTLY
1 Pull the tray completely out.
2 Check for paper jams or misfeeds.
3 Make sure the guides are aligned against the edges of the paper.
4 Insert the tray.
RESET THE PRINTER
Turn the printer off, wait about 10 seconds, and then turn the printer on.
Flash memory card
Make sure the flash memory card is securely connected to the printer system board.
Memory card
Make sure the memory card is securely connected to the printer system board.
Solving paper feed problems
Paper frequently jams
These are possible solutions. Try one or more of the following:
CHECK THE PAPER
Use recommended paper and other specialty media. For more information, see “Paper and specialty media
guidelines” on page 44.
MAKE SURE THERE IS NOT TOO MUCH PAPER IN THE TRAY OR FEEDER
Make sure the stack of paper you load does not exceed the maximum stack height indicated in the tray or on the
multipurpose feeder.
CHECK THE GUIDES
Move the guides in the tray to the correct positions for the paper size loaded.
Troubleshooting
114

Lexmark E360D series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Standard Memory	32 MB
Processor Speed	400 MHz
Print Speed	Up to 35 ppm
Input Capacity	250-Sheet Input Tray
Output Capacity	150 sheets
Media Types Supported	Plain Paper, Card Stock, Envelopes, Transparencies
Media Sizes Supported	Letter, legal, executive, A4, A5, B5, envelopes
Recommended Monthly Page Volume	750 to 3, 000 pages
Connectivity	USB 2.0
Print Languages	PCL 6, PostScript 3
Weight	14.0 kg
Supported Operating Systems	Windows, Linux, Mac OS X
Duplex Printing	Standard