Lexmark E360D series User Manual

Ordering a photoconductor kit
Depending on your printer model, the printer issues a message or a light sequence to let you know the
photoconductor kit is near its end of life. At this time, order a photoconductor kit. You can also see the status of the
photoconductor kit by printing a network setup page.
Part name Part number
Photoconductor kit E260X22G
Replacing supplies
Replacing the toner cartridge
When 88 Cartridge is low appears, or when you experience faded print, remove the toner cartridge. Firmly
shake it side-to-side and front-to-back several times to redistribute the toner, and then reinsert it and continue
printing. When shaking the cartridge no longer improves the print quality, replace the toner cartridge.
Note: You can check to see approximately how much toner is left in your cartridge by printing a menu settings page.
To replace the toner cartridge:
1 Open the front door by pressing the button on the left side of the printer and lowering the door.
2 Press the button on the base of the photoconductor kit, and then pull the toner cartridge out using the handle.
Maintaining the printer
84

Lexmark E360D series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Standard Memory	32 MB
Processor Speed	400 MHz
Print Speed	Up to 35 ppm
Input Capacity	250-Sheet Input Tray
Output Capacity	150 sheets
Media Types Supported	Plain Paper, Card Stock, Envelopes, Transparencies
Media Sizes Supported	Letter, legal, executive, A4, A5, B5, envelopes
Recommended Monthly Page Volume	750 to 3, 000 pages
Connectivity	USB 2.0
Print Languages	PCL 6, PostScript 3
Weight	14.0 kg
Supported Operating Systems	Windows, Linux, Mac OS X
Duplex Printing	Standard