Notes on EPEAT-registered imaging equipment products:
•
Standby power level occurs in Hibernate or O mode.
• The product shall automatically power down to a standby power level of ≤ 1 W. The auto standby function
(Hibernate or O) shall be enabled at product shipment.
O
mode
If this product has an o mode which still consumes a small amount of power, then to completely stop product
power consumption, disconnect the power supply cord from the electrical outlet.
Total energy usage
It is sometimes helpful to estimate the total product energy usage. Since power consumption claims are
provided in power units of Watts, the power consumption should be multiplied by the time the product spends
in each mode in order to calculate energy usage. The total product energy usage is the sum of each mode's
energy usage.
Applicability of Regulation (EU) 2019/2015 and (EU) 2019/2020
Per Commission Regulation (EU) 2019/2015 and (EU) 2019/2020, the light source contained within this product
or its component is intended to be used for Image Capture or Image Projection only, and is not intended for
use in other applications.
Thailand NBTC technical standards conformity statement
คําประกาศเรื่องการเป็นไปตามมาตรฐานทางเทคนิคของ กสทช. ประเทศไทย
This telecommunication equipment conforms to the technical standards or requirements of NBTC.
เครื่องโทรคมนาคมและอุปกรณนี
้
มีความสอดคลองตามมาตรฐานหรือขอก
ํ
าหนดทางเทคนิคของ กสทช.
Regulatory notices for wireless products
This section contains regulatory information that applies only to wireless models.
If in doubt as to whether your model is a wireless model, then see
“Wireless support” on page 46.
Modular component notice
Wireless models contain the following modular component:
AzureWave AW-CM467-SUR; FCC ID:TLZ-CM467; IC:6100A-CM467
To determine which modular components are installed in your particular product, refer to the labeling on your
actual product.
Notices 182
To Next Page
Loading...
