4 Load the paper stack with the printable side facedown, and then make sure that the guides fit snugly against
the paper.
Notes:
• Load letterhead facedown with the header toward the front of the tray for one‑sided printing.
• Load letterhead faceup with the header toward the back of the tray for two‑sided printing.
• Do not slide paper into the tray.
• To avoid paper jams, make sure that the stack height is below the maximum paper fill indicator.
5 Insert the tray.
If necessary, set the paper size and paper type from the control panel to match the paper loaded.
Loading the multipurpose feeder
1 Open the multipurpose feeder.
Set up, install, and configure 29
To Next Page
Loading...
