Menu item Description
Printer Emulations
PS Emulation
O
On*
Set the printer to recognize and use the PS data stream.
Printer Emulations
Enable Formsmerge
O*
On
Activate Forms Merge to store the forms into the hard disk or
intelligent storage drive (ISD).
Note: A hard disk or an ISD must be installed.
Printer Emulations
Enable Prescribe
O*
On
Activate Prescribe.
Note: The Prescribe license must be installed.
Printer Emulations
Emulator Security
Page Timeout (60 minutes*)
Reset Emulator After Job (O*)
Disable Printer Message Access (On*)
Configure the security settings of the printer during emulation
mode.
Print Configuration
Font Sharpening
0–150 (24*)
Set a text point-size value below which the high‑frequency
screens are used when printing font data.
For example, if the value is 24, then all fonts sized 24 points or
less use the high‑frequency screens.
Print Configuration
Print Density
Disabled
1–5 (3*)
Adjust the toner density when printing documents.
Device Operations
Quiet Mode
O*
On
Set the printer to operate in Quiet Mode.
Note: Enabling this setting slows down the overall
performance of the printer.
Device Operations
Safe Mode
O*
On
Set the printer to operate in a special mode, in which it attempts
to continue oering as much functionality as possible, despite
known issues.
For example, when set to On, and the duplex motor is
nonfunctional, the printer performs one‑sided printing of the
documents even if the job is two‑sided printing.
Device Operations
Clear Custom Status
Erase user‑defined strings for the Default or Alternate custom
messages.
Device Operations
Clear all remotely‑installed messages
Erase messages that were remotely installed.
Note: An asterisk (*) next to a value indicates the factory default setting.
Use printer menus 69
To Next Page
Loading...
