Fonts
70
Fonts
The fonts provided by the Forms and Bar Code Card for emulation of JetCAPS BarDIMM Pro (Bar
Codes & More) are listed as follows:
HRT Location (of
the linear
component)
int 0=Default
1=No HRT
2=Embedded
3=Half-Embedded
4=Under
Dependent on the
default HRT
Location of the
linear component,
except for
UCC-128, which
uses Under as its
default value.
Corresponds to the HP #p parameter
If an HRT Location of 5 (above) is
specified, the bar code engine is
automatically set to HalfEmbedded.
Other invalid values will be set to the
default.
HRT Typeface (of
the linear
component)
int 0=Courier
1=SM Gothic
2=SM Unit
3=SM Unit
Condensed
4=Roman
5=OCRB
0 (dec) or 00 (hex) Optional
Corresponds to the HP #h parameter
Note: When the value given is not
within the defined range, the value will
be set to default (Courier).
Font Type Resides
Architext CMC7 Scalable In option card
CMC7 Scalable In option card
Code 39 Bitmap In option card
Code 39 - 4.69 Pitch Bitmap In option card
Code 39 - 8.11 Pitch Bitmap In option card
Code 39 Narrow Scalable In printer
Code 39 Regular Scalable In printer
Code 39 Wide Scalable In printer
Code 39 Half Inch Scalable In option card
Code 39 One Inch Scalable In option card
Code 39 Quarter Inch Scalable In option card
Code 39 Small High Scalable In option card
Code 39 Medium Scalable In option card
Code 39 Low Regular Scalable In option card
Field Name Type Range
Default (if not
specified)
Definition
The dimensions of the composite bar code may be varied in only two directions.
• The module height of the linear component is varied using the V parameter.
• The module width of the linear component is varied using the B parameter.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
