Lexmark MX710 - Page 304

Action Yes No
Step 3
a Depending on your operating system, specify the paper size from
Printing Preferences or from the Print dialog.
b Resend the print job.
Is the page or image clipped?
Go to step 4. The problem is solved.
Step 4
a Reinstall the imaging unit.
1 Remove the toner cartridge.
2 Remove the imaging unit.
Warning—Potential Damage: Do not expose the imaging unit to
direct light for more than 10 minutes. Extended exposure to
light may cause print quality problems.
3 Install the imaging unit, and then the cartridge.
b Resend the print job.
Is the page or image clipped?
Contact
customer
support.
The problem is solved.
Compressed images appear on prints
Note: Printing on letter-size paper using a 220-volt fuser compresses images.
Action Yes No
Step 1
a Make sure the size of the paper loaded in the tray matches the fuser
type.
Note: Use a 110-volt fuser for printing on letter-size paper and a
220-volt fuser for printing on A4‑size paper.
b Resend the print job.
Do compressed images still appear?
The problem is solved. Go to step 2.
Step 2
a Replace the fuser. For more information on installing the fuser, see
the instruction sheet that came with the part.
b Resend the print job.
Do compressed images still appear?
The problem is solved. Contact
customer
support.
Troubleshooting 304