Action Yes No
Step 2
Replace the imaging unit, and then resend the print job.
Does fog or shading appear on prints?
Contact
customer
support at
http://support.lexmar
k.com or your service
representative.
The problem is solved.
Toner rubs off
Leading edge
Trailing edge
ABC
DEF
Action Yes No
Step 1
From the Paper menu on the printer control panel, check the paper type
and weight.
Do the paper type and texture match the paper loaded in the tray?
Go to step 2. Specify the paper type
and weight from the
tray settings to match
the paper loaded in the
tray.
Step 2
Check if you are printing on paper with texture or rough finishes.
Are you printing on textured or rough paper?
From the Paper menu
on the printer control
panel, set the paper
texture.
Contact
customer
support.
Uneven print density
Action Yes No
Replace the imaging unit, and then resend the print job.
Is the print density uneven?
Contact
customer
support.
The problem is solved.
Solving copy problems
• “Copier does not respond” on page 320
Troubleshooting 319
To Next Page
Loading...
