Lexmark T656 - Page 96

Composite bar codes
93
/ModuleWidth (of
the linear
component)
int Dependent on the
module width
range of the linear
component.
Dependent on the
default module
width of the linear
component.
Optional.
Sets the X dimension of the
two-dimentional module (white or black
rectangle) in one-hundreths of an inch.
/EmbedText (of
the linear
component)
name /NoText
/Embedded
/HalfEmbedded
/Under
Dependent on the
default HRT
Location of Linear
Component,
except for
UCC-128, which
uses Under as its
default value.
Defines if and where the HRT is to be
printed.
If /Above is specified, BCE
automatically sets it to /HalfEmbedded.
Other invalid values will be set to the
default.
/FontName (of the
linear component)
name See these
sections:
• Values for /
EmbedText key
• Values for /
FontName key
/Courier-Bold Optional.
Defines how the HRT is to be printed.
When the value given is not within the
defined range:
• If the value is of type name, the
value will be set to default (/
Courier-Bold)
• If the value is of any other type, a
TYPECHECK error will be returned.
Key Type Range
Default (if not
specified)
Definition
The data in a Postscript bar code sequence is represented within parentheses, for example: (0123456789).
For Composite bar codes, the sequence uses the “pipe” character “|” to extend the sequence.
For example, this is a UPC-A Composite example sequence:
(12345678901|Lexmark)
<< /Symbology /UPC-A >> barcodeshow
• UPC-A data begins with “12345678901”
• Followed by a “|” pipe character
• Followed by the Composite data string: “Lexmark”
• Followed by a the UPC-A symbology sequence
• Followed by the Postscript barcodeshow operator.