Lexmark X945 - E-Mail Server Setup Menu

Menu item Description
IPv6
Enable DHCPv6
Yes
No
Enables DHCPv6 in the printer
Note: No is the factory default setting.
E-mail Server Setup menu
Use the following menu to configure the SMTP e-mail server.
Menu item Description
E-mail Server Setup
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
Specifies SMTP server port information
Note: 25 is the default SMTP gateway port.
E-mail Server Setup
SMTP Timeout
5–30
Specifies the amount of time in seconds before the server stops
trying to send the e-mail
Note: 30 seconds is the factory default setting.
E-mail Server Setup
SMTP Server Authentication
Off
Device Userid and password
User ID and password
User e-mail and password
Specifies the type of user authentication required for scan to e-mail
privileges
Note: Off is the factory default setting.
E-mail Server Setup
Device Userid
Password
Reply Address
Subject
Message
Specifies e-mail server information
Note: The message box has a limitation of 512 characters.
E-mail Server Setup
Send me a copy
Never appears
On by default
Off by default
Always On
Sends a copy of the e-mail back to the creator of the e-mail
E-mail Server Setup
Max e-mail size
0–65535 kB
Specifies the maximum e-mail size in kilobytes
Note: E-mail above the specified size is not sent.
E-mail Server Setup
Size Error Message
Sends a message when an e-mail is greater than the configured size
limit
183