Lexmark X945 - Standard Usb Port Disabled; Too Many Disks Installed; Too Many Flash Options Installed; Too Many Trays Attached

56 Parallel port <x> disabled
• Touch Continue to clear the message.
The printer discards any data received through the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
56 Serial port <x> disabled
• Touch Continue to clear the message.
The printer discards any data received through the serial port.
• Make sure the Serial Buffer menu item is not set to Disabled.
56 Standard USB port disabled
• Touch Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
56 USB port <x> disabled
• Touch Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
57 Configuration change, held jobs were not restored
Touch Continue to clear the message.
58 Too many disks installed
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the extra disks.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many flash options installed
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess flash memory.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many trays attached
1 Turn the printer power off.
2 Unplug the power cord from the wall outlet.
3 Remove the additional trays.
200