Lexmark X952 - Page 56

56
5.2.1.2.2 Dual Staple (IPDS Edge stitch with 2 staples)
Parameters in the printer file
Edge Stitch
Reference edge...........*LEFT, *TOP or *DEVD
Reference edge offset....*DEVD
Number of staples........*DEVD or 2
Staple offsets...........*DEVD
Two staples are placed on the left or top reference edge of the paper.
* TOP must only be used with short edge fed paper.
* LEFT must only be used with long edge fed paper.
An invalid staple position parameter may cause an exception to be reported to the host.
The “Reference edge offset”. “Number of staples”, and “Staple offsets” parameters are not supported.
Drawing of staple placement
Text
Text
Text text text text
Text shown with 0
degree rotation
specified in IPDS job
*LEFT
*DEVD
Long-edge fed paper,
leading edge
Text Text text text text text text.
Text shown with 0
degree rotation
specified in IPDS job
*TOP
*DEVD
Short-edge fed paper,
leading edge