Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless
remote control.
1 Turn the power switch off.
2
Cancel the intrusion sensor
*
and tilt sensor
*
of the alarm system to prevent
unintended triggering of the alarm while changing the settings.
3
When the indicator light on the key surface is not on, press and hold
or
for approximately 5 seconds while pressing and holding .
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step 3.)
Multi-information display/Beep
Unlocking function
Exterior: Beeps 3 times
Interior: Pings once
Holding the driver’s door handle unlocks
only the driver’s door.
Holding any of the passenger door han-
dles unlocks all the doors.
Exterior: Beeps twice
Interior: Pings once
Holding a door handle unlocks all the
doors.
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been changed.
(If a door is not opened within 30 seconds after is pressed, the doors will be
* :
If equipped
1-5. Entering/exiting the vehicle and loading luggage
137
1
Before driving
To Next Page
Loading...
