212
4-3. Adjusting the temperature/environment inside the vehicle
■ Operating conditions of seat heaters
The power switch is in ON
■ Operating conditions of radiant heaters
The power switch is in ON and seat belt is
fastened.
Vehicles without radiant heaters:
Select or on the center display.
Vehicles with radiant heaters: Select
or on the center display.
Each time the switch is selected, the
operation condition changes as fol-
lows.
AUTO Hi (3 segments lit) Mid
(2 segments lit) Lo (1 segment lit)
Off
The level indicator (red) lights up
during operation. AUTO indicator
lights up during automatic operation.
■ The radiant heater can be used when
● The power may be turned off automati-
cally be continually touching the heater
section. In that case, turn the radiant
heater switch on the center display again.
● It may take some time for the heater tem-
perature to rise.
■ Position of the radiant heaters
Front passenger’s side radiant heater
Driver’s side radiant heater
■ Customization
The temperature setting of the seat heaters
of the front seats can be set through “Vehi-
cle customize” on the center display.
(P.595)
Press the switch.
Each time the switch is pressed, the
operation condition changes as fol-
lows.
Hi (3 segments lit) Mid (2 segments
NOTICE
■ To prevent damage to the seat heat-
ers/radiant heaters
Do not put heavy objects that have an
uneven surface on the seat and do not
stick sharp objects (needles, nails, etc.)
into the seat.
■ To prevent 12-volt battery discharge
Do not use the functions when the EV
system is off.
Turn the front seat heaters/radi-
ant heaters ON/OFF
Turns the rear seat heaters on/off
(if equipped)
A
B
To Next Page
Loading...
