252
5-2. Functions of the displays
■ If the steering wheel switches do not
respond when touched (vehicles with a
head-up display)
● It is easier to make the steering wheel
switches respond by moving your thumb
while touching them.
● If the surface of a steering wheel switch is
dirty, turn the power switch off and then
clean the switches.
● By turning winter glove mode on, the sen-
sitivity of the switch sensors can be
increased. (P.583)
■ Customization
Some functions can be customized.
(P.583)
1 Press or of the meter con-
trol switch.
1 Press the or meter control
switch to select . Then press
or .
1 Select on the center display.
2 Select “Vehicle customize”.
3 Select “Meter”.
4 Select or of “Display
switching”.
The display changes each time the switch is
selected.
■ Switching with the steering wheel
switches
If / is set as a favorite
steering wheel switch function, the display
can be switched by pushing or
.
Driving related information is dis-
played on the following displays.
Multi-information display
Head-up display (if equipped)
Center display
The items displayed will differ depend-
ing on the display.
The following items can be displayed
on the multi-information display.
Use the displayed values as a refer-
ence only.
Current electricity consumption
Displays the instantaneous current elec-
tricity consumption.
Average electricity consumption
■ Electricity consumption
● For U.S.A.
Electricity consumption is the consumption
rate of the electricity and equivalent to the
fuel consumption for the gasoline vehicles.
For this vehicle, driven distance per kWh of
electricity consumed (“miles/kWh”) is dis-
played as electricity consumption on each
Switching the display of the
multi-information display (vehi-
cles without a head-up display)
Switching driving information (vehi-
cles without a head-up display)
Switching the display of the
multi-information display (vehi-
cles with a head-up display)
Display of drive information
Drive information 1
To Next Page
Loading...
