362
6-2. Using the safe driving support functions
Pedestrian detection icon
Displayed automatically when a pedestrian
is detected.
The RCD can be enabled/disabled on
of the center display. (P.593)
When the RCD function is off, the driv-
ing assist information indicator
(P.240) will illuminate. At this time,
the message will be displayed on the
multi-information display.
Each time the power switch is turned to
ON, the RCD function is enabled.
If the rear camera detection function
detects a pedestrian in the detection
area, the buzzer and pedestrian detec-
tion will operate as follows:
If a pedestrian is detected in area
Buzzer: Sounds repeatedly
Pedestrian detection icon: Blinks
If a pedestrian is detected in area
Buzzer (When the vehicle is sta-
tionary): Sounds 3 times
Buzzer (When the vehicle is back-
ing up, when a pedestrian
approaches the rear of the vehicle):
Sounds repeatedly
Pedestrian detection icon: Blinks
If the system determines that your
vehicle may collide with a pedes-
trian in area
WARNING
● Do not install market protection parts
(bumper trim, etc.) to the rear bumper.
● Maintain suitable tire air pressure.
● Make sure the back door is completely
closed.
■ RCD function is turned off
In the following situations the system
turns off. The RCD function may not
operate properly and thus there is the
danger that an accident may occur.
● The contents mentioned above are not
observed.
● Suspensions other than genuine parts
are installed.
RCD display
Turning the RCD function on/off
A
Pedestrian detection area
A
B
C
To Next Page
Loading...
