489
9-2. If a warning is indicated on the meter
9
When trouble arises
*
: Electricity is consumed when operating traction battery heater. Using My Room Mode
also consumes power.
“Charging Stopped Due to Pulled Charging Connector”
Cause Remedy
AC charging connector is
removed while AC charging
After the traction battery is fully
charged, the AC charging con-
nector is removed while the trac-
tion battery is being recharged
again because electricity-con-
suming functions
*
have been used
and the remaining charge is now
reduced.
If the AC charging connector is disconnected
during AC charging, charging will be suspended. To
continue charging, reconnect the AC charging con-
nector.
AC charging connector is not
securely connected
Check the connection status of the AC charging
connector.
When connecting the AC charging connector,
make sure not to touch the latch release button.
Insert the AC charging connector securely until
you hear a click. The AC charging connector may
not be connected correctly if the latch release
button is pressed while inserting.
After connecting the AC charging connector,
check that the latch release button is not pressed
and the charging indicator of the charging port is
turned on.
If charging cannot be carried out, even though the
proper procedures were followed, have the vehicle
inspected by your Lexus dealer.
Latch release button of AC charging
connector was pressed while
charging
When the latch release button is pressed while AC
charging, charging stops. To continue AC charging,
reconnect the AC charging connector.
To Next Page
Loading...
