351
6-3. Do-it-yourself maintenance
6
Maintenance and care
■ Front turn signal lights (vehicles
with single-beam headlights)
1 Turn the bulb base counterclock-
wise.
2 Remove the light bulb.
3 When installing, reverse the steps
listed.
Replacing light bulb
■ Replacing light bulb
● Turn off the light. Do not attempt to
replace the bulb immediately after
turning off the light.
The bulb become very hot and may
cause burns.
● Do not touch the glass portion of the
light bulb with bare hands. When it is
unavoidable to hold the glass portion,
use and hold with a clean dry cloth to
avoid getting moisture and oils on the
bulb.
Also, if the bulb is scratched or
dropped, it may blow out or crack.
● Fully install light bulb and any parts
used to secure it. Failure to do so may
result in heat damage, fire, or water
entering the light unit. This may dam-
age the light or cause condensation to
build up on the lens.
■ To prevent damage or fire
● Make sure bulb is fully seated and
locked.
● Check the wattage of the bulb before
installing to prevent heat damage.
To Next Page
Loading...
