Operation
GA10218_002_C0 - 10/2016 - © Leybold GmbH 83
3.11.1 Service
Main menu > Information > Service
With the main menu special functions can be accomplished (e. g. manual switching
of the valves). The access to the service menu is protected by a PIN. This PIN is
not communicated with the delivery of the leak detector but after an adequate ser
-
vice training.
3.12 Access Control
Main menu > Access control
With this menu you can deny or allow access to specific functions of the PHOENIX
L300i.
3.12.1 Zero
Main menu > Access control > Zero
This setting enables (respectively disables) the ZERO button at the control panel.
With „Zero at FINE“, the ZERO functions executes automatically as soon as the
measuring range FINE is reached for the first time after START. In this mode the
ZERO function also can be executed manually via the ZERO button.
Fig. 32 Display: Access Control Menu
Softkey 3 Zero
Settings of the zero function
Softkey 4: Access to CAL function
Settings for restriction of the CAL function
Softkey 8: Change Menu-Pin
Access to menu pin can be restricted
To Next Page
Loading...
