Need help?Do you have a question about the LEYBOLD PhoeniXL300 and is the answer not in the manual?
General| Pumping Speed (for He) | 2.5 l/s |
|---|---|
| Detectable Gases | Helium, Hydrogen |
| Start-up Time | < 3 minutes |
| Supply Voltage | 50/60 Hz |
| Interfaces | RS232, USB |
| Minimum Detectable Leak Rate (Helium) | 5×10⁻¹² mbar·l/s |
| Type | Portable helium leak detector |
Lists technical specifications for the PhoeniXL300 model.
Specifies technical data unique to the PhoeniXL300 dry version.
Specifies technical data for the PhoeniXL300 Modul version.
Details on connecting the PhoeniXL to mains power.
Step-by-step guide for initial startup and measurement.
Explains how to perform an internal calibration.
Describes accuracy verification using an external test leak.
Describes the PhoeniXL control panel buttons and displays.
Explains Vacuum Method, Partial Flow Method, and Sniffer Mode.
Describes display content during measurement.
Details settings for trigger levels, volume, and alarms.
Explains the importance and methods of calibration.
Describes how to start and access internal/external calibration.
Lists and describes various error and warning messages.
Provides instructions on how to safely open the PhoeniXL.
To Next Page
