Head
40
⏐
GA10218_0101 - 5/2002
4.1.6 Controls on the Remote Control (Optio-
nal)
An overview of the controls on the remote control is given in Fig 13.
START-button Based on the operating modes Standby or Vent of the PhoeniXL, the
START-button is used to start the measurement mode by evacuating the
connected test sample. Here the PhoeniXL will operate either with auto-
matic ranging or it will only display the measured values within a fixed
range which has been selected by the operator.
The status of measurement readiness is indicated to the operator by a
green LED at the START-button. During the pumpdown phase this LED
flashes. As soon as the status of measurement readiness has been rea-
ched, this LED stays on continiously.
When pressing the START-button in the Standby mode, the internal Zero
Fig. 13 View of remote control
1 ZERO button 8 Scale for the pressure in
2 STOP / VENT button the test sample
3 START button 9 Exponent
4 LED Bargraph display 10 LED Lock
5 Underflow display 11 Acoustic signal quiter
(under range) 12 Acoustic signal louder
6 Leak rate scale
7 Overflow display
(over range)
10
11
12
To Next Page
Loading...
