LFA TDP 6s - Installation; Tools and Materials Needed; The Appropriate Workstation for the Machine

To Next Page

To Previous Page

Installation

Tools and Materials Needed

Before you install and operate the TDP 6s

, it is best to have the following tools and materials on

hand for general operation and maintenance:

• Engine hoist or lift and lifting strap

• Mounting materials such as:

• Non-slip pad (such as a yoga mat cut to ﬁt the machine's base) OR anti-vibration pads

• Power drill

• Hammer

• Gear puller

• Rubber mallet

• Metric wrench set

• Pliers/grippers

• Flathead screwdriver

• Set of metric Allen keys with ball ends

• Long wire pipe cleaner

• Lubricant (NSF approved for food grade products)

• Grease gun

• Toothbrush

• Bagless vacuum

• Sanitizer (e.g. Maker's Mark Commercial Sanitizer)

• Cleaning brush set

• Plastic sheet or something similar to cover machine

• Safety goggles

• Disposable latex/rubber gloves

• Hairnet and/or beard net (food grade products only)

• Sterile shoe covers (food grade products only)

The Appropriate Workstation for the Machine

Find a stable workspace surface that supports the TDP 6s

’s 160 kg (about 352 lbs) weight, such

as a wooden bench (use stainless steel if for food grade industry). Another important thing to

consider is to ﬁnd a bench that has a suitable working height for you.

Environmental Conditions

It is important that the environment in which you operate and store the TDP 6s

has the

appropriate temperature and relative humidity levels. These two environmental factors can

potentially cause the machine to rust and/or cause the tablets to have a lower quality. The table

below shows the acceptable temperature and relative humidity levels:

Machine Temperature Humidity

TDP 6s

°C °F 20-80% RH

0-40 32-104