LFA TDP 6s - Repair and Part Replacement

29
Wear Parts and Causes of Damage
Wear Part Cause of Damage
Tooling The Tooling can become chipped or broken. Lead
times for a new set of Tooling can take as long as
6-8 weeks, so LFA recommends having a spare set
or two.
Boot
The TDP 6s
®
Boot is formed from a toughened
plastic. This part can become trapped between
the Die Bore and the Upper Punch, which usually
results from user error.
Boot Timing Bar In the event that the Boot is trapped or damaged by
the Upper Punch, the Boot Timing Bar can become
bent.
V Belts
The V Belts on the TDP 6s
®
is used to drive all of
the power from the Motor to the upper cams.
This can lose some of its tension and wear
over time, which affects the maximum pressure.
Dismantling for Repair and Replacement
Eventually due to wear and tear, some parts of the TDP 6s
®
will need to be removed for repair and
replacement. To prevent any delays in your tablet production, it is best practice to keep extra parts
just in case.
To buy a TDP 6s
®
part replacement, simply go to
https://www.lfatabletpresses.com/products/pill-press-machine-spare-parts/tdp-6s-parts
Warranty
To access LFA's warranty policy, go to https://www.lfatabletpresses.com/warranty
If your part is eligible for warranty, have your part’s serial number on hand and please contact LFA:
UK
Phone
+44 (0) 0345 165 20 25
Email
sales@lfamachines.com
Taiwan
Phone
+886 2773 74704
Email
sales.asia@lfamachines.com
USA
Phone
(682) 312-0309
Email
sales.usa@lfamachines.com
WARNING: To prevent any potential personal injury, ALWAYS unplug the TDP 6s
®
from the electrical outlet when replacing parts.