46
4. Take off the Boot carefully and remove any powder that is inside of it.
5. Turn the Hand Wheel in the reverse direction for a few rotations.
6. Position the Boot on the Base Plate.
7. Insert the Boot Timing Bar's end in the new Boot.
8. Resecure the Boot Bolt and Spring underneath the new Boot.
9. Tighten the Boot’s set screw with an Allen key.
10. Reattach the Ejection Tray with a crosshead screwdriver.
11. Reinsert the Hopper.
12. Turn the Hand Wheel for one rotation to ensure that the machine runs smoothly before plugging
it in and turning it on.
To Next Page
Loading...