CAUTION
• Do not give damage to the pipe/base during the knock out work.
• Proceed to pipe work after removing burr.
•
Perform sleeve work to prevent damage to the wire when connecting wires using knock outs.
• Take care so that there is no thermal damage on the service valves of the outdoor unit.
(Especially packing part of service port.) Wrap the service valve with a wet towel when
brazing it as shown figure above.
!
※Pictures may differ depending on the model.
Remove leakage prevention cap
• Remove the leakage prevention cap attached to the outdoor unit service valve before pipe
work.
• Proceed the leakage prevention cap removal as follows:
- Verify whether the liquid/gas pipes are locked.
- Extract remaining refrigerant or air inside using the service port.
- Remove the leakage prevention cap
To Next Page
Loading...
