LG APUW100LFT0 - Function; Dip Switch Setting

FUNCTION
29
ENGLISH
Dip switch setting
Setting Procedure
- Set the Dip Switch as follow after shutting the power source down.
- Open the side panel or Top Cover of outdoor unit.
- Set the DIP_SW01D.
- If you set the Dip Switch when power is on, the change in setting is not applicable. The chang-
ing setting is enabled only when power is reset.
- Close the side panel or Top Cover.
FUNCTION
Dip Switch
Function
APUQ100LFT0
APUW100LFT0
1 2 3 4 5 6 7 8 9 10
12345678910
Normal Operation (No Function) O
12345678910
Forced Cooling Operation O
12345678910
Saving Power Consumption (Step 1) X
12345678910
Saving Power Consumption (Step 2) X
12345678910
Mode Lock (Cooling) X
12345678910
Mode Lock (Heating) X
12345678910
Night Quiet Mode (Step 1) X
12345678910
Night Quiet Mode (Step 2) X
12345678910
Mode Lock (Cooling) + Night Quiet Mode (Step 1) X
12345678910
Mode Lock (Cooling) + Night Quiet Mode (Step 2) X
12345678910
Mode Lock (Cooling) + Saving Power Consumption (Step 1) X
12345678910
Mode Lock (Cooling) + Saving Power Consumption (Step 2) X
12345678910
Mode Lock (Heating) + Saving Power Consumption (Step 1) X
12345678910
Mode Lock (Heating) + Saving Power Consumption (Step 2) X
12345678910
Pressure compensation function O
12345678910
Dew formation avoidance function O
• Unless the applicable dip switch is set properly, the product may not work.
• If you want to set a specific function, request that the installer sets the dip switch appro-
priately during installation.
CAUTION
!
• When you set the dip switch, you should turn off the circuit breaker or shut the power
source of the product down.
WARNING
!