20
REMOTE CONTROLLER INSTALLATION
ENGLISH
Please fix tightly using provided screw after placing remote controller setup
board on the place where you like to setup.
- Please set it up not to bend because poor setup could take place if setup board bends.
Please set up remote controller board fit to the reclamation box if there is a reclamation box.
- Install the product so as not to make a gap with the wall side and to prevent shaking after the
installation.
Can set up Wired remote controller cable into three directions.
- Setup direction: the surface of wall reclamation, upper, right
- If setting up remote controller cable into upper and right side, please set up after removing
remote controller cable guide groove.
* Remove guide groove with long nose.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
1
2
3
2
3
<Wire guide grooves>
REMOTE CONTROLLER INSTALLATION
1,MFL67939930,영영 2018. 3. 16. 영영 2:25 Page 20
To Next Page
Loading...
