28
OPTIONAL OPERATION
ENGLISH
Function Code Dry Contact
setting value
Select Dry contact setting by
pressing button.
(00 : Automatic, 01 : manual)
3
Press button to save.
4
If pressing button long for 3
seconds, it enters into remote controller
setter setup mode.
- If pressing once shortly, it enters into
user setup mode. Please press more
than 3 seconds for sure.
1
If pressing button repeatedly, it moves to
remote controller dry contact mode setup menu
as picture below.
2
Pressing button will exit settings mode.
❈ After setup, it automatically gets out of setup
mode if there is no button input for 25
seconds.
❈ When exiting without pressing set button, the
manipulated value is not reflected.
5
Installer Setting-Dry Contact Mode Setting
Dry contact function is the function that is possible to use only when dry contact equipment is
separately purchased/setup.
What is Dry Contact?
Like hotel card key and body perception sensor, it is the signal of the point of contact when using
air-conditioner by interlocking.
- Please refer to dry contact manual for more details.
1,MFL67939930,영영 2018. 3. 16. 영영 2:25 Page 28
To Next Page
Loading...
