OPTIONAL OPERATION
ENGLISH
23
Installer Setting -Test Run Mode
After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
Press button to start.
3
During the test run, pressing the below
button will exit the test run.
- Select operation, temperature up/down,
wind flow control, wind direction,
start/stop button.
4
If pressing button long for 3 seconds, it
enters into remote controller setter setup
mode.
- If pressing once shortly, it enters into user
setup mode. Please press more than 3
seconds for sure.
- Please cancel the right and left of wind
direction for RAC product.
1
Setup figure '01' blinks at the lower part of
indication window.
2
Function Code Set
OPTIONAL OPERATION
1,MFL67939930,영영 2018. 3. 16. 영영 2:25 Page 23
To Next Page
Loading...
