DRYER
INSTALLATION (Stacking Kit)
WARNING! Do not attempt this alone! At least two people are required to lift the
dryer and place it properly on top of the washer. Failure to observe this warning
could result in serious physical injury and damage to the appliances.
1. Place the washer on a solid,
even floor. If you plan to use a
pedestal, install it now before
going any further.
2. Peel the protective paper from
the adhesive tape on the side
bracket.
3. Fit the side bracket firmly to the
top plate using the adhesive
tape, as shown in the drawing.
4. Secure the bracket to the top
plate using a screw, as shown.
Repeat steps 2, 3, and 4 for the
other side.
5. Level the dryer on a firm solid
floor and lock down the
adjusters before placing it on top
of the washer. (See page xx.)
Lift the dryer on top of the
washer it toward the front of the
washer, as shown.
Slide the dryer all the way back
to the stop on the rail.
DLE8377xM/DLG8388xM
DLE7177WM/DLE7188WM Page 11 of 60 TRAINING MANUAL
To Next Page
Loading...
Need help?
General
